After a change for dynamic server capabilities, the code to send out mode
changes was changed to use the capabilities belonging to the last mode
being sent out. This does not make sense; therefore, just use no
capabilities and remove supporting infrastructure.
Reported by ssbr on freenode:
chmode +c doesn't strip ^O, which turns off all previous formatting.
This can cause clients that internally use mIRC formatting to render messages weirdly,
e.g. highlighted messages in HexChat: <https://i.imgur.com/eDX8Aif.png>.
Charybdis currently leaks about 45-50k per configuration parse,
including every rehash. This change plugs these leaks by properly
iterating through all conf_parm_t structures to seek all strings that
should be freed and also by freeing the conf_parm_t structures
themselves.
These leaks have been present since the original rewrite of the
configuration parsing system in ircd-ratbox r11953.
Additionally, this change also cleans up and documents the parsing code
a bit.
Default values for default_floodcount and default_ident_timeout are set
in s_conf.c. Remove code that checks for missing values in ircd.c.
Additionally, reset default_ident_timeout to 5 if an invalid value (i.e.
0) is provided.
Add the flags (auth{} spoof, dynamic spoof) to struct Whowas and add a
show_ip_whowas().
Normal users now see IPs of unspoofed users, and remote opers can see IPs
behind dynamic spoofs. Also, general::hide_spoof_ips is now applied when
the IP is shown, not when the client exits.
s_assert requires some higher-level functionality that shouldn't be
present in ircd_defs.h. ircd_defs.h is used by ssld, which has no notion
of logging or sending IRC messages. Additionally, some of the headers
s_assert depends on result in conflicting definitions in ssld.c.
This change also fixes the compile when using --enable-assert=soft.
With this comes an example module to block the killing of services.
NOTE: this will not cancel remote kills. Those are still accepted, per
the TS 6 specification.
A zero CAP_CAP caused duplicate CAPAB to go undetected, allowing a
mismatch between what is sent out via ENCAP GCAP and what applies locally.
A zero CAP_TS6 allowed server connections without SID (with a valid
connect block).
Currently, the resolver treats SERVFAIL, NOTIMP, and REFUSED queries the
same as NXDOMAIN, but this really should not be the case. Instead, if
the DNS server errors on our request or provides an invalid request, try
another server.
Also, count DNS server errors in addition to timeouts and avoid these
undesirable servers.
This will allow us to modularize message processing, e.g. having new modules to manipulate
channel and private messages in new ways.
Yes: it can be used to intercept messages, but such modules are already out in the wild for
charybdis anyway -- so this doesn't really change anything there.
If you are changing the text, then it is your responsibility to provide a pointer to a new
buffer. This buffer should be statically allocated and stored in your module's BSS segment.
We will not, and cannot, free your buffer in core, so dynamically allocated buffers will
cause a memory leak.
This will allow us to simplify m_message considerably, by moving channel mode logic out to
their own modules.
Add two mechanism for avoiding name-collisions in a system-wide
installation of charybdis. The ssld and bandb daemons, intended to be
directly used by ircd and not the user, install into libexec when
--enable-fhs-paths is set. For binaries which are meant to be in PATH
(bindir), such as ircd and viconf, there is now an option
--with-program-prefix=progprefix inspired by automake. If the user
specifies --with-program-prefix=charybdis, the ircd binary is named
charybdisircd when installed.
Add support for saving the pidfile to a rundir and storing the ban
database in localstatedir instead of in sysconfdir. This is, again,
conditional on --enable-fhs-paths.
Fix(?) genssl.sh to always write created SSL key/certificate/dh
parameters to the sysconfdir specified during ./configure. The
previous behavior was to assume that the user ran genssl.sh after
ensuring that his current working directory was either sysconfdir or a
sibling directory of sysconfdir.
This becomes important because of away-notify sending aways to common
channels much like nick changes (which are also paced).
Marking as unaway is not limited (but obviously only does something if the
user was away before). To allow users to fix typos in away messages, two
aways are allowed in sequence if away has not been used recently.
Specifically, what this capability manager does, is map keywords to
calculated bitmasks. These bitmasks are allocated at runtime, so that
the any managed capability index can be manipulated by modules.
Modules should call capability_orphan() when orphaning capabilities. This
makes it so that bitmasks aren't reallocated, except for cases where the
capability is the same.
This adds a new ISUPPORT token, NICKLEN_USABLE which is strictly an informative value.
NICKLEN is always the maximum runtime NICKLEN supported by the IRCd, as other servers may
have their own usable NICKLEN settings. As NICKLEN_USABLE is strictly informative, and
NICKLEN is always the maximum possible NICKLEN, any clients which depend on NICKLEN for
memory preallocation will be unaffected by runtime changes to NICKLEN_USABLE.
The default NICKLEN is 50; the default serverinfo::nicklen in the config file is set to
30, which is the NICKLEN presently used on StaticBox.
* Deduce allow_read from the client's state (IsFloodDone) rather than
storing it in LocalUser.
* Fix the documentation (in oper /info), however strange
client_flood_burst_rate and client_flood_burst_max may seem, that is
how they currently work.
nenolod gave the thumbs-up to port ircd-seven banfowards to charybdis to spb
for a while, and people have asked about it. Might as well do it since it's a
slow weekend.
Note that as a side effect use_forward is removed from the config and
unconditionally enabled!
While what chanroles are trying to accomplish is a good idea, it is
apparently unclear this is the proper way to do it. Until we figure out
the exact way we wish to do this, it should be reverted for now.
The theory behind this is that services sends an ENCAP * GRANT #channel
UID :+flagspec message specifying the chanroles the user has. They are
mapped into flag bits and applied to the membership of the user. They
then are restricted or permitted to what they can do based on the
permissions mask regardless of rank.
For backwards compatibility, the default permission bit (without a GRANT
statement) allows a user to to anything an existing op can do ONLY if
they are an op.
Todo: make CHANROLE_STATUS work (the ability to apply +ov to people),
which is at the moment controlled by CHANROLE_MODE.
The extended-join client capability extends the JOIN message with information clients typically
query using WHO including accountname, signon TS and realname.
This has a separate enabling option channel::channel_target_change.
It applies to PRIVMSG, NOTICE and TOPIC by unvoiced unopped non-opers.
The same slots are used for channels and users.
The code behind this capability was never implemented, and subsequent
discussions have agreed to approach the problem differently. There seems no
reason to continue advertising a capability that does nothing.
* does not apply to NOTICE (as those may well be automated)
* mirrors +g behaviour so that no useless accept entries are added for services
* respects max_accept, if it would be exceeded the message is dropped with numeric 494
* check moved up so this is checked before floodcount/tgchange
